Download or read book Approximate Airframe Transfer Functions and Application to Single Sensor Control Systems written by Irving L. Ashkenas and published by . This book was released on 1958 with total page 234 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Topics on Flexible Airplane Dynamics The application of flexible airframe transfer function approximations and the sensitivity of airframe transfer functions to elastic mode shapes written by and published by . This book was released on 1963 with total page 62 pages. Available in PDF, EPUB and Kindle. Book excerpt: pt.3: The dynamic coupling of rigid and elastic degrees of freedom of an airplane are described by two methods. In the first, coupling is described by the changes in airframe characteristic equation roots caused by the introduction of coupling terms to the equations of motion. The second method employs modal response coefficients to compare the relative amplitudes of rigid and elastic degrees of freedom at each coupled mode frequency. Simple literal expressions are obtained for each of these descriptors and physical interpretations given. Time vector diagrams are also used to show the major parameters affecting coupling. (Author).
Download or read book Aircraft Dynamics and Automatic Control written by Duane T. McRuer and published by Princeton University Press. This book was released on 2014-07-14 with total page 809 pages. Available in PDF, EPUB and Kindle. Book excerpt: Aeronautical engineers concerned with the analysis of aircraft dynamics and the synthesis of aircraft flight control systems will find an indispensable tool in this analytical treatment of the subject. Approaching these two fields with the conviction that an understanding of either one can illuminate the other, the authors have summarized selected, interconnected techniques that facilitate a high level of insight into the essence of complex systems problems. These techniques are suitable for establishing nominal system designs, for forecasting off-nominal problems, and for diagnosing the root causes of problems that almost inevitably occur in the design process. A complete and self-contained work, the text discusses the early history of aircraft dynamics and control, mathematical models of linear system elements, feedback system analysis, vehicle equations of motion, longitudinal and lateral dynamics, and elementary longitudinal and lateral feedback control. The discussion concludes with such topics as the system design process, inputs and system performance assessment, and multi-loop flight control systems. Originally published in 1974. The Princeton Legacy Library uses the latest print-on-demand technology to again make available previously out-of-print books from the distinguished backlist of Princeton University Press. These editions preserve the original texts of these important books while presenting them in durable paperback and hardcover editions. The goal of the Princeton Legacy Library is to vastly increase access to the rich scholarly heritage found in the thousands of books published by Princeton University Press since its founding in 1905.
Download or read book U S Government Research Reports written by and published by . This book was released on 1959 with total page 1018 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Topics on Flexible Airplane Dynamics Coupling of the rigid and elastic degrees of freedom of an airframe written by and published by . This book was released on 1963 with total page 86 pages. Available in PDF, EPUB and Kindle. Book excerpt: pt.3: The dynamic coupling of rigid and elastic degrees of freedom of an airplane are described by two methods. In the first, coupling is described by the changes in airframe characteristic equation roots caused by the introduction of coupling terms to the equations of motion. The second method employs modal response coefficients to compare the relative amplitudes of rigid and elastic degrees of freedom at each coupled mode frequency. Simple literal expressions are obtained for each of these descriptors and physical interpretations given. Time vector diagrams are also used to show the major parameters affecting coupling. (Author).
Download or read book Stability and Control of Airplanes and Helicopters written by Edward Seckel and published by Academic Press. This book was released on 2014-05-10 with total page 523 pages. Available in PDF, EPUB and Kindle. Book excerpt: Stability and Control of Airplanes and Helicopters deals with aircraft flying qualities that determine the stability and control of airplanes and helicopters. It includes problems based on real aircraft, selected to represent the gamut from simple to complicated, and from conventional utility designs to futuristic research types. Many of these problems involve comparison of theory and experiment to demonstrate their mutual relationship. Comprised of 25 chapters, this book begins with a discussion on the aerodynamics of the component parts related to the lift and moment characteristics of an airplane, including wings and associated accessories; bodies such as fuselages, nacelles, and tip tanks; and control surfaces. The reader is then introduced to some mathematical techniques for linear differential equations; steady flight at different speeds; and stick force and control-free stability. Subsequent chapters focus on flaps and high-lift devices; power and compressibility effects; and the manner in which the aircraft responds to the application of control. Aeroelasticity and longitudinal equations of motion are also examined. This monograph is intended for undergraduate and graduate students taking modern engineering courses.
Download or read book Analysis of Several Handling Quality Topics Pertinent to Advanced Manned Aircraft written by Systems Technology, Inc and published by . This book was released on 1967 with total page 234 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report presents the results of analytical studies of a variety of handling quality topics related to advanced manned aircraft.
Download or read book An Analytical Study of V STOL Handling Qualities in Hover and Transition written by R. L. Stapleford and published by . This book was released on 1965 with total page 174 pages. Available in PDF, EPUB and Kindle. Book excerpt: The hover analysis considers pilot attitude and position control tasks in the presence of horizontal gusts. The effects of each of the stability derivatives on the difficulty of the control tasks and on the closed-loop gust responses are determined. It is clearly shown that the handling qualities studies of control sensitivity and angular damping must consider the influences of M sub u (or L sub v) and should include gust inputs. These conclusions are substantiated by previous variable-stability-helicopter experiments. The effects of vehicle size and geometry are investigated by several approaches. The key result of increasing size is found to be a reduction in M sub u and L sub v which can, in turn, lower the requirements for control power and damping. The handling qualities during transition of two vehicles, a tilt duct and a tilt wing, which were previously tested on a simulator are analyzed. It is shown that both trim control and perturbations about the trim conditions must be considered. In fact, part of the increased difficulty in landing transitions, in comparison with takeoff transitions, is due to more difficult trim control; the much more stringent position control requirements in landing are also a contributing factor.
Download or read book Response of Aircraft Encountering Aircraft Wake Turbulence written by Robert C. Nelson and published by . This book was released on 1974 with total page 144 pages. Available in PDF, EPUB and Kindle. Book excerpt: The investigation deals with the dynamic behavior of an airplane encountering aircraft wake turbulence. A digital computer simulation was developed to study the response of an aircraft flying into a trailing vortex wake. The simulation includes the complete six degree of freedom equations of motion, a description of the vortex velocity field, unsteady aerodynamics, and pilot control input. The parameters included the penetration angle, separation distance, aircraft size, and pilot control input. Predicted vortex induced motions are presented for general aviation, business, and light jet transport type aircraft.
Download or read book U S Government Research Reports written by and published by . This book was released on 1964 with total page 716 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Airplane Stability and Control written by Malcolm J. Abzug and published by Cambridge University Press. This book was released on 2002-09-23 with total page 417 pages. Available in PDF, EPUB and Kindle. Book excerpt: From the early machines to today's sophisticated aircraft, stability and control have always been crucial considerations. In this second edition, Abzug and Larrabee again forge through the history of aviation technologies to present an informal history of the personalities and the events, the art and the science of airplane stability and control. The book includes never-before-available impressions of those active in the field, from pre-Wright brothers airplane and glider builders through to contemporary aircraft designers. Arranged thematically, the book deals with early developments, research centers, the effects of power on stability and control, the discovery of inertial coupling, the challenge of stealth aerodynamics, a look toward the future, and much more. It is profusely illustrated with photographs and figures, and includes brief biographies of noted stability and control figures along with a core bibliography. Professionals, students, and aviation enthusiasts alike will appreciate this readable history of airplane stability and control.
Download or read book NASA University Conference on Manual Control written by and published by . This book was released on 1966 with total page 438 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Influence of Response Feedback Loops on the Lateral directional Dynamics of a Variable stability Transport Aircraft written by Kenneth J. Szalai and published by . This book was released on 1967 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book NASA Technical Note written by and published by . This book was released on 1972 with total page 696 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Proceedings written by NASA-University Conference on Manual Control and published by . This book was released on 1966 with total page 438 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Proposed MIL Standard and Handbook Proposed mil handbook written by Roger H. Hoh and published by . This book was released on 1982 with total page 902 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Study of Conventional Airplane Handling Qualities Requirements written by I. L. Ashkenas and published by . This book was released on 1965 with total page 40 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report is a codification in two parts of conventional aircraft handling qualities criteria. The results of this effort are to serve as an intermediate design guide in the areas of lateral-directional oscillatory and roll control. The roll handling qualities portion of this report uses as a point of departure the concept that control of bank angle is the primary piloting task in maintaining or changing heading. In the lateral oscillatory portion of this effort, in defining requirements for satisfactory Dutch roll characteristics, a fundamental consideration is the fact that the motions characterizing this mode are ordinarily not the pilot's chief objective. That is, he is not deliberately inducing Dutch roll motions in the sense that he induces rolling and longitudinal short-period motions. A worthwhile approach to establishment of Dutch roll damping requirements is to first establish the basic level, and then to study the varied influences of the disturbance parameters. This approach provides the basis for the material contained in this report.
