Download or read book Analytical Heat and Fluid Flow in Microchannels and Microsystems written by Renato M. Cotta and published by Springer. This book was released on 2015-10-10 with total page 175 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book focuses on the modeling and analysis of heat and fluid flow in microchannels and micro-systems, compiling a number of analytical and hybrid numerical-analytical solutions for models that account for the relevant micro-scale effects, with the corresponding experimental analysis validation when applicable. The volume stands as the only available compilation of easy to use analytically-based solutions for micro-scale heat and fluid flow problems, that systematically incorporates the most relevant micro-scale effects into the mathematical models, followed by their physical interpretation on the micro-system behavior.

Download or read book Fluid Flow Heat Transfer and Boiling in Micro Channels written by L. P. Yarin and published by Springer Science & Business Media. This book was released on 2008-09-19 with total page 487 pages. Available in PDF, EPUB and Kindle. Book excerpt: The subject of the book is uid dynamics and heat transfer in micro-channels. This problem is important for understanding the complex phenomena associated with single- and two-phase ows in heated micro-channels. The challenge posed by high heat uxes in electronic chips makes thermal management a key factor in the development of these systems. Cooling of mic- electronic components by new cooling technologies, as well as improvement of the existing ones, is becoming a necessity as the power dissipation levels of integrated circuits increases and their sizes decrease. Miniature heat sinks with liquid ows in silicon wafers could signi cantly improve the performance and reliability of se- conductor devices. The improvements are made by increasing the effective thermal conductivity, by reducing the temperature gradient across the wafer, by reducing the maximum wafer temperature, and also by reducing the number and intensity of localized hot spots. A possible way to enhance heat transfer in systems with high power density is to change the phase in the micro-channels embedded in the device. This has motivated a number of theoretical and experimental investigations covering various aspects of heat transfer in micro-channel heat sinks with phase change. The ow and heat transfer in heated micro-channels are accompanied by a n- ber of thermohydrodynamic processes, such as liquid heating and vaporization, bo- ing, formation of two-phase mixtures with a very complicated inner structure, etc., which affect signi cantly the hydrodynamic and thermal characteristics of the co- ing systems.

Download or read book Heat Transfer and Fluid Flow in Minichannels and Microchannels written by Satish Kandlikar and published by Elsevier. This book was released on 2006 with total page 492 pages. Available in PDF, EPUB and Kindle. Book excerpt: &Quot;This book explores flow through passages with hydraulic diameters from about 1 [mu]m to 3 mm, covering the range of minichannels and microchannels. Design equations along with solved examples and practice problems are also included to serve the needs of practicing engineers and students in a graduate course."--BOOK JACKET.

Download or read book Heat Transfer and Fluid Flow in Microchannels written by G. P. Celata and published by . This book was released on 2004 with total page 248 pages. Available in PDF, EPUB and Kindle. Book excerpt: This first book in a new series in Thermal an Fluid Physics and Engineering, edited by Professor G.F. Hewitt, is of particular importance to the field at the present time. Edited by Professor F.P. Celata, the topic of microchannels is finding a very large range of applications, particularly in the context of cooling of electronic equipment. Fluid flow and heat transfer process at the microscale bring into play many aspects that are not significant at the macro scale. The book fills a void in the existing literature and covers a large body of new knowledge in the thermal-fluid dynamics theory and applications in micro-geometries. The volume also presents a critical assessment of the state-of-the-art in the field. Intended for both academic and industrial audiences.

Download or read book Finite Difference Methods in Heat Transfer written by M. Necati Özişik and published by CRC Press. This book was released on 2017-07-20 with total page 580 pages. Available in PDF, EPUB and Kindle. Book excerpt: Finite Difference Methods in Heat Transfer, Second Edition focuses on finite difference methods and their application to the solution of heat transfer problems. Such methods are based on the discretization of governing equations, initial and boundary conditions, which then replace a continuous partial differential problem by a system of algebraic equations. Finite difference methods are a versatile tool for scientists and for engineers. This updated book serves university students taking graduate-level coursework in heat transfer, as well as being an important reference for researchers and engineering. Features Provides a self-contained approach in finite difference methods for students and professionals Covers the use of finite difference methods in convective, conductive, and radiative heat transfer Presents numerical solution techniques to elliptic, parabolic, and hyperbolic problems Includes hybrid analytical–numerical approaches

Download or read book Proceedings of 15th International Conference on Electromechanics and Robotics Zavalishin s Readings written by Andrey Ronzhin and published by Springer Nature. This book was released on 2020-09-01 with total page 553 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book features selected papers presented at the 15th International Conference on Electromechanics and Robotics “Zavalishin's Readings” – ER(ZR) 2020, held in Ufa, Russia, on 15–18 April 2020. The contributions, written by professionals, researchers and students, cover topics in the field of automatic control systems, electromechanics, electric power engineering and electrical engineering, mechatronics, robotics, automation and vibration technologies. The Zavalishin's Readings conference was established as a tribute to the memory of Dmitry Aleksandrovich Zavalishin (1900–1968) – a Russian scientist, corresponding member of the USSR Academy of Sciences and founder of the school of valve energy converters based on electric machines and valve converters energy. The first conference was organized by the Institute of Innovative Technologies in Electromechanics and Robotics at the Saint Petersburg State University of Aerospace Instrumentation in 2006.

Download or read book Heat Conduction Fifth Edition written by Sadık Kakac and published by CRC Press. This book was released on 2018-07-11 with total page 543 pages. Available in PDF, EPUB and Kindle. Book excerpt: Heat Conduction, Fifth Edition, upholds its reputation as the leading text in the field for graduate students, and as a resource for practicing engineers. The text begins with fundamental concepts, introducing the governing equation of heat conduction, and progresses through solutions for one-dimensional conduction, orthogonal functions, Fourier series and transforms, and multi-dimensional problems. Integral equations, Laplace transforms, finite difference numerical methods, and variational formulations are then covered. A systematic derivation of the analytical solution of heat conduction problems in heterogeneous media, introducing a more general approach based on the integral transform method, has been added in this new edition, along with new and revised problems, and complete problem solutions for instructors.

Download or read book Microfluidics Based Microsystems written by S. Kakaç and published by Springer. This book was released on 2010-06-30 with total page 621 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume contains an archival record of the NATO Advanced Study Institute on Microfluidics Based Microsystems – Fundamentals and App- cations held in Çe ?me-Izmir, Turkey, August 23–September 4, 2009. ASIs are intended to be high-level teaching activity in scientific and technical areas of current concern. In this volume, the reader may find interesting chapters and various microsystems fundamentals and applications. As the world becomes increasingly concerned with terrorism, early - spot detection of terrorist’s weapons, particularly bio-weapons agents such as bacteria and viruses are extremely important. NATO Public Diplomacy division, Science for Peace and Security section support research, Advanced Study Institutes and workshops related to security. Keeping this policy of NATO in mind, we made such a proposal on Microsystems for security. We are very happy that leading experts agreed to come and lecture in this important NATO ASI. We will see many examples that will show us Microfluidics usefulness for rapid diagnostics following a bioterrorism attack. For the applications in national security and anti-terrorism, microfluidic system technology must meet the challenges. To develop microsystems for security and to provide a comprehensive state-of-the-art assessment of the existing research and applications by treating the subject in considerable depth through lectures from eminent professionals in the field, through discussions and panel sessions are very beneficial for young scientists in the field.

Download or read book Microscale Heat Transfer Fundamentals and Applications written by S. Kakaç and published by Springer Science & Business Media. This book was released on 2006-05-20 with total page 517 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume contains an archival record of the NATO Advanced Institute on Microscale Heat Transfer – Fundamental and Applications in Biological and Microelectromechanical Systems held in Çesme – Izmir, Turkey, July 18–30, 2004. The ASIs are intended to be high-level teaching activity in scientific and technical areas of current concern. In this volume, the reader may find interesting chapters and various Microscale Heat Transfer Fundamental and Applications. The growing use of electronics, in both military and civilian applications has led to the widespread recognition for need of thermal packaging and management. The use of higher densities and frequencies in microelectronic circuits for computers are increasing day by day. They require effective cooling due to heat generated that is to be dissipated from a relatively low surface area. Hence, the development of efficient cooling techniques for integrated circuit chips is one of the important contemporary applications of Microscale Heat Transfer which has received much attention for cooling of high power electronics and applications in biomechanical and aerospace industries. Microelectromechanical systems are subject of increasing active research in a widening field of discipline. These topics and others are the main themeof this Institute.

Download or read book Gas Flows in Microsystems written by Lucien Baldas and published by MDPI. This book was released on 2019-10-28 with total page 220 pages. Available in PDF, EPUB and Kindle. Book excerpt: The last two decades have witnessed a rapid development of microelectromechanical systems (MEMS) involving gas microflows in various technical fields. Gas microflows can, for example, be observed in microheat exchangers designed for chemical applications or for cooling of electronic components, in fluidic microactuators developed for active flow control purposes, in micronozzles used for the micropropulsion of nano and picosats, in microgas chromatographs, analyzers or separators, in vacuum generators and in Knudsen micropumps, as well as in some organs-on-a-chip, such as artificial lungs. These flows are rarefied due to the small MEMS dimensions, and the rarefaction can be increased by low-pressure conditions. The flows relate to the slip flow, transition or free molecular regimes and can involve monatomic or polyatomic gases and gas mixtures. Hydrodynamics and heat and mass transfer are strongly impacted by rarefaction effects, and temperature-driven microflows offer new opportunities for designing original MEMS for gas pumping or separation. Accordingly, this Special Issue seeks to showcase research papers, short communications, and review articles that focus on novel theoretical and numerical models or data, as well as on new experimental results and technics, for improving knowledge on heat and mass transfer in gas microflows. Papers dealing with the development of original gas MEMS are also welcome.

Download or read book Microscale and Nanoscale Heat Transfer written by Mourad Rebay and published by CRC Press. This book was released on 2016-01-06 with total page 499 pages. Available in PDF, EPUB and Kindle. Book excerpt: Microscale and Nanoscale Heat Transfer: Analysis, Design, and Applications features contributions from prominent researchers in the field of micro- and nanoscale heat transfer and associated technologies and offers a complete understanding of thermal transport in nano-materials and devices. Nanofluids can be used as working fluids in thermal system

Download or read book Applied Chemistry and Chemical Engineering Volume 1 written by A. K. Haghi and published by CRC Press. This book was released on 2017-12-22 with total page 296 pages. Available in PDF, EPUB and Kindle. Book excerpt: This new book brings together innovative research, new concepts, and novel developments in the application of informatics tools for applied chemistry and computer science. It presents a modern approach to modeling and calculation and also looks at experimental design in applied chemistry and chemical engineering. The volume discusses the developments of advanced chemical products and respective tools to characterize and predict the chemical material properties and behavior. Providing numerous comparisons of different methods with one another and with different experiments, not only does this book summarize the classical theories, but it also exhibits their engineering applications in response to the current key issues. Recent trends in several areas of chemistry and chemical engineering science, which have important application to practice, are discussed. Applied Chemistry and Chemical Engineering: Volume 1: Mathematical and Analytical Techniques provides valuable information for chemical engineers and researchers as well as for graduate students. It demonstrates the progress and promise for developing chemical materials that seem capable of moving this field from laboratory-scale prototypes to actual industrial applications. Volume 2 will focus principles and methodologies in applied chemistry and chemical engineering.

Download or read book Heat Transfer and Fluid Flow in Minichannels and Microchannels written by Satish Kandlikar and published by Butterworth-Heinemann. This book was released on 2013-10-25 with total page 588 pages. Available in PDF, EPUB and Kindle. Book excerpt: Heat exchangers with minichannel and microchannel flow passages are becoming increasingly popular due to their ability to remove large heat fluxes under single-phase and two-phase applications. Heat Transfer and Fluid Flow in Minichannels and Microchannels methodically covers gas, liquid, and electrokinetic flows, as well as flow boiling and condensation, in minichannel and microchannel applications. Examining biomedical applications as well, the book is an ideal reference for anyone involved in the design processes of microchannel flow passages in a heat exchanger. - Each chapter is accompanied by a real-life case study - New edition of the first book that solely deals with heat and fluid flow in minichannels and microchannels - Presents findings that are directly useful to designers; researchers can use the information in developing new models or identifying research needs

Download or read book Microsystems Mechanical Design written by Francesco De Bona and published by Springer Science & Business Media. This book was released on 2007-03-23 with total page 219 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book introduces the basic tools used in the mechanical design of microsystems, the fabrication methods for these systems, and several applications of this technology. The links between micro- and nanotechnologies are also discussed and light is shed on the potential applications of microsystems to nano-scale manipulation of matter. The book is a systematic, updated and quite complete treatise of its subject.

Download or read book Heat Transfer Fluid Flow Analysis and Energy Management of Micro channel Heat Sinks Using Vortex Generators and Nanofluids written by Mushtaq Talib Khazaal Al-Asadi and published by . This book was released on 2018 with total page 190 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Microsystem Engineering of Lab on a chip Devices written by Oliver Geschke and published by John Wiley & Sons. This book was released on 2006-08-21 with total page 270 pages. Available in PDF, EPUB and Kindle. Book excerpt: Written by an interdisciplinary team of chemists, biologists and engineers from one of the leading European centers for microsystem research, MIC in Lyngby, Denmark, this book introduces and discusses the different aspects of (bio)chemical microsystem development. Unlike other, far more voluminous and theoretical books on this topic, this is a concise, practical handbook, dealing with analytical applications, particularly in the life sciences. Topics include: * microfluidics * silicon micromachining * glass and polymer micromachining * packaging * analytical chemistry illustrated with examples taken mainly from ongoing research projects at MIC.

Download or read book Heat Transfer and Pressure Drop in Flow Boiling in Microchannels written by Sujoy Kumar Saha and published by Springer. This book was released on 2015-07-08 with total page 63 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Brief addresses the phenomena of heat transfer and pressure drop in flow boiling in micro channels occurring in high heat flux electronic cooling. A companion edition in the Springer Brief Subseries on Thermal Engineering and Applied Science to “Critical Heat Flux in Flow Boiling in Micro channels,” by the same author team, this volume is idea for professionals, researchers and graduate students concerned with electronic cooling.