Download or read book An Investigation of Particle Size Measurement Using Non Intrusive Optical Techniques in a Gas Turbine Combustor written by John S. Bennett and published by . This book was released on 1985 with total page 51 pages. Available in PDF, EPUB and Kindle. Book excerpt: This thesis investigated the use of three-wavelength light transmission and forward-angle scattered light intensity ratio techniques to determine the effects of fuel additives on particle sizes and mass concentrations in a T-63 combustor and evaluated several improvements to the T-63 diagnostic system. Data from both optical methods indicated an increase in particle size in a range of .06 to .10 microns occurred in the exhaust region when the fuel additive was used, with no change in mass concentration. The two techniques resulted in different measured particle sizes and require further investigation. Current improvements to the T-63 diagnostic apparatus are discussed along with required changes for further testing.
Download or read book Masters Theses in the Pure and Applied Sciences written by Wade H. Shafer and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 386 pages. Available in PDF, EPUB and Kindle. Book excerpt: Masters Theses in the Pure and Applied Sciences was first conceived, published, and disseminated by the Center for Information and Numerical Data Analysis and Synthesis (CINDAS) * at Purdue University in 1957, starting its coverage of theses with the academic year 1955. Beginning with Volume 13, the printing and dissemination phases of the activity were transferred to University Microfilms/Xerox of Ann Arbor, Michigan, with the thougtit that such an arrangement would be more beneficial to the academic and general scientific and technical community. After five years of this joint undertaking we had concluded that it was in the interest of all con cerned if the printing and distribution of the volumes were handled by an interna tional publishing house to assure improved service and broader dissemination. Hence, starting with Volume 18, Masters Theses in the Pure and Applied Sciences has been disseminated on a worldwide basis by Plenum Publishing Cor poration of New York, and in the same year the coverage was broadened to include Canadian universities. All back issues can also be ordered from Plenum. We have reported in Volume 31 (thesis year 1986) a total of 11 ,480 theses titles trom 24 Canadian and 182 United States universities. We are sure that this broader base tor these titles reported will greatly enhance the value ot this important annual reterence work. While Volume 31 reports theses submitted in 1986, on occasion, certain univer sities do re port theses submitted in previousyears but not reported at the time.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1989 with total page 508 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1995 with total page 994 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Comparison of Techniques for Non Intrusive Fuel Drop Size Measurements in a Subscale Gas Turbine Combustor written by and published by . This book was released on 1999 with total page 16 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fossil Energy Update written by and published by . This book was released on 1982 with total page 940 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Recent Advances in Spray Combustion written by Kenneth K. Kuo and published by AIAA. This book was released on 1996 with total page 488 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Flow and Combustion in Advanced Gas Turbine Combustors written by Johannes Janicka and published by Springer Science & Business Media. This book was released on 2012-10-29 with total page 495 pages. Available in PDF, EPUB and Kindle. Book excerpt: With regard to both the environmental sustainability and operating efficiency demands, modern combustion research has to face two main objectives, the optimization of combustion efficiency and the reduction of pollutants. This book reports on the combustion research activities carried out within the Collaborative Research Center (SFB) 568 “Flow and Combustion in Future Gas Turbine Combustion Chambers” funded by the German Research Foundation (DFG). This aimed at designing a completely integrated modeling and numerical simulation of the occurring very complex, coupled and interacting physico-chemical processes, such as turbulent heat and mass transport, single or multi-phase flows phenomena, chemical reactions/combustion and radiation, able to support the development of advanced gas turbine chamber concepts
Download or read book Environmental Sensing and Applications written by Society of Photo-optical Instrumentation Engineers and published by SPIE-International Society for Optical Engineering. This book was released on 1999 with total page 486 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Measuring Techniques in Gas Liquid Two Phase Flows written by J.M. Delhaye and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 756 pages. Available in PDF, EPUB and Kindle. Book excerpt: A IUTAM symposium on "Measuring Techniques in Gas-Liquid Two Phase Flows" was held on July 5-8, 1983 in Nancy, France. This topic in cluded instrumentation for steam-water and liquid-vapor flows but strictly excluded measuring techniques for gas or liquid flows with solid particles. The top priority in the paper selection was given to presentations of new methods which had been substantiated by theoretical modeling, calibration tests and comparison tests with other techniques. Examples of experimental resul ts obtained with the proposed instrumentation had to be displayed. However the interpretation of these results in terms of two-phase flow or heat transfer modeling did not fall wi thin the scope of the meeting. Thirty four papers were presented during the Symposium and 79 participants coming from Canada, European countries, Japan and the United States attended the sessions. They represented not only Universities but also state agencies and private companies. After the meeting each paper was peer-reviewed by at least three referees. The Editors of this Procee dings Volume are pleased to extend their deep gratitude to the following reviewers: J.L. Achard, R.J. Adrian, B. Azzopardi, J.A. Boure, G. Costigan, M. Courtaud, A.E. Dukler, F. Durst, J.R. Fincke, G. Gouesbet, P. Griffith, T.J. Hanratty, A. Hawighorst, T.R. Heidrick, G. Hetsroni, Y.Y. Hsu, M.
Download or read book Flowfield Modeling and Diagnostics written by Ashwani K. Gupta and published by Taylor & Francis. This book was released on 1985 with total page 426 pages. Available in PDF, EPUB and Kindle. Book excerpt: First published in 2004. Routledge is an imprint of Taylor & Francis, an informa company.
Download or read book Combustings Flow Diagnostics written by D.F.G. Durão and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 566 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book consists of papers prepared for and presented at a NATO sponsored Advanced Study Institute which was held in Montechoro, Portugal during the period 16-27 April, 1990. This Institute was attended by approximately ninety delegates from fifteen countries and followed from a related Institute held in Vimeiro, Portugal in 1987 (see the book entitled "Instrumentation for Combustion and Flow in Engines", edited by D. F. G. Dur~o, J. H. Whitelaw and P. O. Witzel. The purposes of the first Institute related closely to instrumentation for use in gas-turbine combustors and the cylinders of internal-combustion engines. These topics were also addressed in the second Institute, though in a manner which was wider ranging and chosen to demonstrate and explain the development and application of measurement methods to combusting flows in general. The papers contained in this boo~ were selected to provide the reader with a comprehensive and up-to-date view of the variety of experimental techniques available to measure in combusting flows. Included are discussions of their range and applicability, potential accuracy and ease of use. Thus, the first paper provides a brief overview and the second an indication of those aspects of combustion which should influence the choice of flow property to be measured and the technique to be used.
Download or read book Spectroscopic Atmospheric Environmental Monitoring Techniques written by Klaus Schäfer and published by SPIE-International Society for Optical Engineering. This book was released on 1998 with total page 292 pages. Available in PDF, EPUB and Kindle. Book excerpt: This collection of papers from the EOS/SPIE Remote Sensing Symposium includes articles on a variety of relevant issues and topics.
Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1985 with total page 864 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Applied Optical Measurements written by Markus Lehner and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 465 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a compilation of important optical techniques applied to experiments in heat and mass transfer, multiphase flow and combustion. The emphasis of this book is on the application of these techniques to various engineering problems. The contributions are aiming to provide practicing engineers, both in industry and research, with the recent state of science in the application of advanced optical measurements. The book is written by selected specialists representing leading experts in this field who present new information for the possibilities of these techniques and give stimulation of new ideas for their application.
Download or read book An Experimental Investigation of Sooting Characteristics of a Gas Turbine Combustor and Augmentor Tube written by Richard Howard Lindsay and published by . This book was released on 1988 with total page 72 pages. Available in PDF, EPUB and Kindle. Book excerpt: An experimental investigation was conducted to examine the effects of fuel air ratio, fuel additives, fuel composition and inlet air temperature on particle sizes in a gas turbine combustor and augmentor tube. Equipment improvements led to validation of two optical sizing techniques, three-wavelength light transmittance and three-angle forward light scattering. Generally, data obtained agreed well with results of earlier investigations. Particle size variations within the combustor due to changing variables were documented. Effects of changing variables were dependent on inlet conditions and station. Fuel-air ratio had no effect on combustor or augmentor tube exhaust particle size. Keywords: Particle size, Gas turbine combustor, Test cell, Transmittance, Forward light scattering. (MJM).
Download or read book Paper written by and published by . This book was released on 1996 with total page 528 pages. Available in PDF, EPUB and Kindle. Book excerpt:
