Download or read book Shallow Foundations written by Braja M. Das and published by CRC Press. This book was released on 2017-02-03 with total page 330 pages. Available in PDF, EPUB and Kindle. Book excerpt: Following the popularity of the previous edition, Shallow Foundations: Bearing Capacity and Settlement, Third Edition, covers all the latest developments and approaches to shallow foundation engineering. In response to the high demand, it provides updated data and revised theories on the ultimate and allowable bearing capacities of shallow foundations. Additionally, it features the most recent developments regarding eccentric and inclined loading, the use of stone columns, settlement computations, and more. Example cases have been provided throughout each chapter to illustrate the theories presented.
Download or read book Dynamic Bearing Capacity of Soils written by Jack K. Poplin and published by . This book was released on 1967 with total page 146 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Model Study of Dynamically Loaded Square Footings on Dry Sand written by Jack K. Poplin and published by . This book was released on 1969 with total page 114 pages. Available in PDF, EPUB and Kindle. Book excerpt: The investigation reported herein was undertaken to develop an approach to modeling displacements of surface and shallow-buried footings on dry sand subject to high-intensity, single-pulse loads. A hypothetical shallow-bured structure with an isolated footing loaded by airblast overpressure produced by detonation of a nuclear weapon was assumed for design of load pulses on nine model footings used: footing widths of 4.5, 6.0, and 7.5 in. and depth-of-burial to footing width ratios of 0, 0.5, and 1.0. The principles of similitude were used to scale length, force, and time in the models. The models were placed in mobile test bins of uniform, fine, dry sand (90 percent relative density) and subjected to dynamic and static loading. Nondimensional load-displacement relations dependent only on depth-of-burial ratio were developed relating maximum displacement to peak dynamic load, footing width, and soil shear strength gradient. When the dynamic response of the footings in the form of reaction-displacement curves was compared with static response, an increase in initial stiffness and ultimate strength was observed for dynamic loading. However, these dynamic increases were greatest when the static shear strength was lowest, i.e. footings on the surface, and were least for footings buried at a depth equal to its width where the static overburden produced a substantial increase in shear strength. (Author).
Download or read book Dynamic Bearing Capacity of Soils written by Waterways Experiment Station (U.S.) and published by . This book was released on 1963 with total page 184 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book History of Progress written by W. Allen Marr and published by ASCE Publications. This book was released on 2003-01-01 with total page 2392 pages. Available in PDF, EPUB and Kindle. Book excerpt: Sponsored by the Geo-Institute of ASCE This collection of 78 historical papers provides a wide view of the rich body of literature that documents the development of fundamental concepts geotechnical engineering and their application to practical problems. From the highly theoretical to the elegantly practical, the papers in this one-of-a-kind collection are significant for their contributions to the geotechnical engineering literature. Among the writings of more than 60 geotechnical engineering pioneers are several by Karl Terzaghi, widely known as the father of soil mechanics, R.R. Proctor, Arthur Casagrande, and Ralph Peck. Many of these papers contain information as useful today as when they were first written. Others provide great insight into the origins and development of the field and the thought processes of its leaders.
Download or read book Soil Mechanics and Foundation Engineering 2e written by P. Purushothama Raj and published by Pearson Education India. This book was released on 2013 with total page 881 pages. Available in PDF, EPUB and Kindle. Book excerpt: Soil Mechanics and Foundation Engineering, 2e Presents the principles of soil mechanics and foundation engineering in a simplified yet logical manner that assumes no prior knowledge of the subject. It includes all the relevant content required for a sound background in the subject, reinforcing theoretical aspects with comprehensive practical applications.
Download or read book List of Publications of the U S Army Engineer Waterways Experiment Station written by U.S. Army Engineer Waterways Experiment Station and published by . This book was released on 1976 with total page 430 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Technical Report written by and published by . This book was released on 1964 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Response of Soils to Dynamic Loadings written by Robert V. Whitman and published by . This book was released on 1970 with total page 258 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Experimental Studies of Dynamically Loaded Footings on Sand written by Walter E. Fisher and published by . This book was released on 1962 with total page 208 pages. Available in PDF, EPUB and Kindle. Book excerpt: DENTIFIERS: Footings. An investigation of the strength and behavior of spread footings subjected to dynamic forces is reported. To this end a single-degree-of freedom model representing the spread footing and its supporting medium was developed. The supporting medium was restricted to either a cohesive or cohesionless soil. Tests were conducted to aid in the correlation of the model components with the anticipated response behavior of spread footings. A correlation between the analytical model and the experimental results could not justifiably be carried out as the container affected the test medium. Results showed a finite increase in the dynamic bearing capacity of spread footings over their static capacity. Within the limited instrumentation, the dynamic settlement of the test plates is due to the establishment of failure surfaces. For se tlements equal to the maximum dynamic settlement, the applied dynamic load varied from 1.20 to 2.28 times the equivalent static load. (Author).
Download or read book Physical Modelling in Geotechnics Two Volume Set written by Sarah Springman and published by CRC Press. This book was released on 2010-06-17 with total page 1522 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book results from the 7th ICPMG meeting in Zurich 2010 and covers a broad range of aspects of physical modelling in geotechnics, linking across to other modelling techniques to consider the entire spectrum required in providing innovative geotechnical engineering solutions.Topics presented at the conference:Soil - Structure - Interaction;
Download or read book Journal of Geotechnical Engineering written by and published by . This book was released on 1995 with total page 606 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Physical Modelling in Geotechnics Volume 2 written by Andrew McNamara and published by CRC Press. This book was released on 2018-07-11 with total page 1240 pages. Available in PDF, EPUB and Kindle. Book excerpt: Physical Modelling in Geotechnics collects more than 1500 pages of peer-reviewed papers written by researchers from over 30 countries, and presented at the 9th International Conference on Physical Modelling in Geotechnics 2018 (City, University of London, UK 17-20 July 2018). The ICPMG series has grown such that two volumes of proceedings were required to publish all contributions. The books represent a substantial body of work in four years. Physical Modelling in Geotechnics contains 230 papers, including eight keynote and themed lectures representing the state-of-the-art in physical modelling research in aspects as diverse as fundamental modelling including sensors, imaging, modelling techniques and scaling, onshore and offshore foundations, dams and embankments, retaining walls and deep excavations, ground improvement and environmental engineering, tunnels and geohazards including significant contributions in the area of seismic engineering. ISSMGE TC104 have identified areas for special attention including education in physical modelling and the promotion of physical modelling to industry. With this in mind there is a special themed paper on education, focusing on both undergraduate and postgraduate teaching as well as practicing geotechnical engineers. Physical modelling has entered a new era with the advent of exciting work on real time interfaces between physical and numerical modelling and the growth of facilities and expertise that enable development of so called ‘megafuges’ of 1000gtonne capacity or more; capable of modelling the largest and most complex of geotechnical challenges. Physical Modelling in Geotechnics will be of interest to professionals, engineers and academics interested or involved in geotechnics, geotechnical engineering and related areas. The 9th International Conference on Physical Modelling in Geotechnics was organised by the Multi Scale Geotechnical Engineering Research Centre at City, University of London under the auspices of Technical Committee 104 of the International Society for Soil Mechanics and Geotechnical Engineering (ISSMGE). City, University of London, are pleased to host the prestigious international conference for the first time having initiated and hosted the first regional conference, Eurofuge, ten years ago in 2008. Quadrennial regional conferences in both Europe and Asia are now well established events giving doctoral researchers, in particular, the opportunity to attend an international conference in this rapidly evolving specialist area. This is volume 2 of a 2-volume set.
Download or read book Insights and Innovations in Structural Engineering Mechanics and Computation written by Alphose Zingoni and published by CRC Press. This book was released on 2016-11-25 with total page 3395 pages. Available in PDF, EPUB and Kindle. Book excerpt: Insights and Innovations in Structural Engineering, Mechanics and Computation comprises 360 papers that were presented at the Sixth International Conference on Structural Engineering, Mechanics and Computation (SEMC 2016, Cape Town, South Africa, 5-7 September 2016). The papers reflect the broad scope of the SEMC conferences, and cover a wide range of engineering structures (buildings, bridges, towers, roofs, foundations, offshore structures, tunnels, dams, vessels, vehicles and machinery) and engineering materials (steel, aluminium, concrete, masonry, timber, glass, polymers, composites, laminates, smart materials). Some contributions present the latest insights and new understanding on (i) the mechanics of structures and systems (dynamics, vibration, seismic response, instability, buckling, soil-structure interaction), and (ii) the mechanics of materials and fluids (elasticity, plasticity, fluid-structure interaction, flow through porous media, biomechanics, fracture, fatigue, bond, creep, shrinkage). Other contributions report on (iii) recent advances in computational modelling and testing (numerical simulations, finite-element modeling, experimental testing), and (iv) developments and innovations in structural engineering (planning, analysis, design, construction, assembly, maintenance, repair and retrofitting of structures). Insights and Innovations in Structural Engineering, Mechanics and Computation is particularly of interest to civil, structural, mechanical, marine and aerospace engineers. Researchers, developers, practitioners and academics in these disciplines will find the content useful. Short versions of the papers, intended to be concise but self-contained summaries of the full papers, are collected in the book, while the full versions of the papers are on the accompanying CD.
Download or read book List of Publications of the U S Army Engineer Waterways Experiment Station written by Waterways Experiment Station (U.S.) and published by . This book was released on 1973 with total page 322 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book ICPMG2014 Physical Modelling in Geotechnics written by Christophe Gaudin and published by CRC Press. This book was released on 2019-01-08 with total page 1366 pages. Available in PDF, EPUB and Kindle. Book excerpt: The 8th International Conference on Physical Modelling in Geotechnics (ICPMG2014) was organised by the Centre for Offshore Foundation Systems at the University of Western Australia under the auspices of the Technical Committee 104 for Physical Modelling in Geotechnics of the International Society of Soil Mechanics and Geotechnical Engineering. This quadrennial conference is the traditional focal point for the physical modelling community of academics, scientists and engineers to present and exchange the latest developments on a wide range of physical modelling aspects associated with geotechnical engineering. These proceedings, together with the seven previous proceedings dating from 1988, present an inestimable collection of the technical and scientific developments and breakthroughs established over the last 25 years. These proceedings include 10 keynote lectures from scientific leaders within the physical modelling community and 160 peer-reviewed papers from 26 countries. They are organised in 14 themes, presenting the latest developments in physical modelling technology, modelling techniques and sensors, through a wide range of soil-structure interaction problems, including shallow and deep foundations, offshore geotechnics, dams and embankments, excavations and retaining structures and slope stability. Fundamental aspects of earthquake engineering, geohazards, ground reinforcements and improvements, and soil properties and behaviour are also covered, demonstrating the increasing complexity of modelling arising from state-of-the-art technological developments and increased understanding of similitude principles. A special theme on education presents the latest developments in the use of physical modelling techniques for instructing undergraduate and postgraduate students in geotechnical engineering.
Download or read book From Fundamentals to Applications in Geotechnics written by D. Manzanal and published by IOS Press. This book was released on 2015-12-11 with total page 3344 pages. Available in PDF, EPUB and Kindle. Book excerpt: The work of geotechnical engineers contributes to the creation of safe, economic and pleasant spaces to live, work and relax all over the world. Advances are constantly being made, and the expertise of the profession becomes ever more important with the increased pressure on space and resources. This book presents the proceedings of the 15th Pan-American Conference on Soil Mechanics and Geotechnical Engineering (XV PCSMGE), held in Buenos Aires, Argentina, in November 2015. This conference, held every four years, is an important opportunity for international experts, researchers, academics, professionals and geo-engineering companies to meet and exchange ideas and research findings in the areas of soil mechanics, rock mechanics, and their applications in civil, mining and environmental engineering. The articles are divided into nine sections: transportation geotechnics; in-situ testing; geo-engineering for energy and sustainability; numerical modeling in geotechnics; foundations and ground improvement; unsaturated soil behavior; embankments, dams and tailings; excavations and tunnels; and geo-risks, and cover a wide spectrum of issues from fundamentals to applications in geotechnics. This book will undoubtedly represent an essential reference for academics, researchers and practitioners in the field of soil mechanics and geotechnical engineering. In this proceedings, approximately 65% of the contributions are in English, and 35% of the contributions are in Spanish or Portuguese.
