Download or read book A 10 Gb s CMOS Clock and Data Recovery Circuit written by Jafar Savoj and published by . This book was released on 2001 with total page 238 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Monolithic Phase Locked Loops and Clock Recovery Circuits written by Behzad Razavi and published by John Wiley & Sons. This book was released on 1996-04-18 with total page 516 pages. Available in PDF, EPUB and Kindle. Book excerpt: Featuring an extensive 40 page tutorial introduction, this carefully compiled anthology of 65 of the most important papers on phase-locked loops and clock recovery circuits brings you comprehensive coverage of the field-all in one self-contained volume. You'll gain an understanding of the analysis, design, simulation, and implementation of phase-locked loops and clock recovery circuits in CMOS and bipolar technologies along with valuable insights into the issues and trade-offs associated with phase locked systems for high speed, low power, and low noise.
Download or read book Low Jitter Gb s CMOS Clock and Data Recovery Circuits for Large Synchronous Networks written by Sitt Tontisirin and published by . This book was released on 2008 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A CMOS Clock and Data Recovery Circuit for Giga bit s Serial Data Communications written by Hui Wang and published by . This book was released on 1998 with total page 298 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book CMOS Current Mode Circuits for Data Communications written by Fei Yuan and published by Springer Science & Business Media. This book was released on 2007-04-26 with total page 306 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book deals with the analysis and design of CMOS current-mode circuits for data communications. CMOS current-mode sampled-data networks, i.e. switched-current circuits, are excluded. Major subjects covered in the book include: a critical comparison of voltage-mode and current-mode circuits; the building blocks of current-mode circuits: design techniques; modeling of wire channels, electrical signaling for Gbps data communications; ESD protection for current-mode circuits and more. This book will appeal to IC design engineers, hardware system engineers and others.
Download or read book CMOS Multichannel Single Chip Receivers for Multi Gigabit Optical Data Communications written by Paul Muller and published by Springer Science & Business Media. This book was released on 2007-10-29 with total page 207 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the world of optical data communications this book will be an absolute must-read. It focuses on optical communications for short and very short distance applications and discusses the monolithic integration of optical receivers with processing elements in standard CMOS technologies. What’s more, it provides the reader with the necessary background knowledge to fully understand the trade-offs in short-distance communication receiver design and presents the key issues to be addressed in the development of such receivers in CMOS technologies. Moreover, novel design approaches are presented.
Download or read book Circuits at the Nanoscale written by Krzysztof Iniewski and published by CRC Press. This book was released on 2018-10-08 with total page 602 pages. Available in PDF, EPUB and Kindle. Book excerpt: Circuits for Emerging Technologies Beyond CMOS New exciting opportunities are abounding in the field of body area networks, wireless communications, data networking, and optical imaging. In response to these developments, top-notch international experts in industry and academia present Circuits at the Nanoscale: Communications, Imaging, and Sensing. This volume, unique in both its scope and its focus, addresses the state-of-the-art in integrated circuit design in the context of emerging systems. A must for anyone serious about circuit design for future technologies, this book discusses emerging materials that can take system performance beyond standard CMOS. These include Silicon on Insulator (SOI), Silicon Germanium (SiGe), and Indium Phosphide (InP). Three-dimensional CMOS integration and co-integration with Microelectromechanical (MEMS) technology and radiation sensors are described as well. Topics in the book are divided into comprehensive sections on emerging design techniques, mixed-signal CMOS circuits, circuits for communications, and circuits for imaging and sensing. Dr. Krzysztof Iniewski is a director at CMOS Emerging Technologies, Inc., a consulting company in Vancouver, British Columbia. His current research interests are in VLSI ciruits for medical applications. He has published over 100 research papers in international journals and conferences, and he holds 18 international patents granted in the United States, Canada, France, Germany, and Japan. In this volume, he has assembled the contributions of over 60 world-reknown experts who are at the top of their field in the world of circuit design, advancing the bank of knowledge for all who work in this exciting and burgeoning area.
Download or read book Analog Circuit Design written by Michiel Steyaert and published by Springer Science & Business Media. This book was released on 2008-09-19 with total page 361 pages. Available in PDF, EPUB and Kindle. Book excerpt: Analog Circuit Design contains the contribution of 18 tutorials of the 17th workshop on Advances in Analog Circuit Design. Each part discusses a specific to-date topic on new and valuable design ideas in the area of analog circuit design. Each part is presented by six experts in that field and state of the art information is shared and overviewed. This book is number 17 in this successful series of Analog Circuit Design.
Download or read book Clock Multiplier Unit and Clock Data Recovery Circuit for 10Gb s Broadband Communication in 0 18 mu m CMOS written by Jun Cao (researcher in electrical and computer engineering.) and published by . This book was released on 2003 with total page 352 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book CMOS Continuous Time Adaptive Equalizers for High Speed Serial Links written by Cecilia Gimeno Gasca and published by Springer. This book was released on 2014-09-22 with total page 164 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book introduces readers to the design of adaptive equalization solutions integrated in standard CMOS technology for high-speed serial links. Since continuous-time equalizers offer various advantages as an alternative to discrete-time equalizers at multi-gigabit rates, this book provides a detailed description of continuous-time adaptive equalizers design - both at transistor and system levels-, their main characteristics and performances. The authors begin with a complete review and analysis of the state of the art of equalizers for wireline applications, describing why they are necessary, their types, and their main applications. Next, theoretical fundamentals of continuous-time adaptive equalizers are explored. Then, new structures are proposed to implement the different building blocks of the adaptive equalizer: line equalizer, loop-filters, power comparator, etc. The authors demonstrate the design of a complete low-power, low-voltage, high-speed, continuous-time adaptive equalizer. Finally, a cost-effective CMOS receiver which includes the proposed continuous-time adaptive equalizer is designed for 1.25 Gb/s optical communications through 50-m length, 1-mm diameter plastic optical fiber (POF).
Download or read book Analog Circuit Design for Communication SOC written by Steve Hung-Lung Tu and published by Bentham Science Publishers. This book was released on 2012 with total page 238 pages. Available in PDF, EPUB and Kindle. Book excerpt: This e-book provides several state-of-the-art analog circuit design techniques. It presents both empirical and theoretical materials for system-on-a-chip (SOC) circuit design. Fundamental communication concepts are used to explain a variety of topics including data conversion (ADC, DAC, S-? oversampling data converters), clock data recovery, phase-locked loops for system timing synthesis, supply voltage regulation, power amplifier design, and mixer design. This is an excellent reference book for both circuit designers and researchers who are interested in the field of design of analog communic.
Download or read book Clock Multiplier Unit and Clock Data Recovery Circuit for 10Gb s Broadband Communication in 0 18um CMOS written by Jun Cao (researcher in electrical and computer engineering.) and published by . This book was released on 2003 with total page 176 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book High Speed CMOS Circuits for Optical Receivers written by Jafar Savoj and published by Springer Science & Business Media. This book was released on 2007-05-08 with total page 132 pages. Available in PDF, EPUB and Kindle. Book excerpt: With the exponential growth of the number of Internet nodes, the volume of the data transported on the backbone has increased with the same trend. The load of the global Internet backbone will soon increase to tens of terabits per second. This indicates that the backbone bandwidth requirements will increase by a factor of 50 to 100 every seven years. Transportation of such high volumes of data requires suitable media with low loss and high bandwidth. Among the available transmission media, optical fibers achieve the best performance in terms of loss and bandwidth. High-speed data can be transported over hundreds of kilometers of single-mode fiber without significant loss in signal integrity. These fibers progressively benefit from reduction of cost and improvement of perf- mance. Meanwhile, the electronic interfaces used in an optical network are not capable of exploiting the ultimate bandwidth of the fiber, limiting the throughput of the network. Different solutions at both the system and the circuit levels have been proposed to increase the data rate of the backbone. System-level solutions are based on the utilization of wave-division multiplexing (WDM), using different colors of light to transmit s- eral sequences simultaneously. In parallel with that, a great deal of effort has been put into increasing the operating rate of the electronic transceivers using highly-developed fabrication processes and novel c- cuit techniques.
Download or read book Design and Modeling of Clock and Data Recovery Integrated Circuit in 130 Nm CMOS Technology for 10 Gb written by Maher Assaad and published by . This book was released on 2009 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Abstract This thesis describes the design and implementation of a fully monolithic 10 Gb/s phase and frequency-locked loop based clock and data recovery (PFLL-CDR) integrated circuit, as well as the Verilog-A modeling of an asynchronous serial link based chip to chip communication system incorporating the proposed concept. The proposed design was implemented and fabricated using the 130 nm CMOS technology offered by UMC (United Microelectronics Corporation). Different PLL-based CDR circuits topologies were investigated in terms of architecture and speed. Based on the investigation, we proposed a new concept of quarter-rate (i.e. the clocking speed in the circuit is 2.5 GHz for 10 Gb/s data rate) and dual-loop topology which consists of phase-locked and frequency-locked loop. The frequency-locked loop (FLL) operates independently from the phase-locked loop (PLL), and has a highly-desired feature that once the proper frequency has been acquired, the FLL is automatically disabled and the PLL will take over to adjust the clock edges approximately in the middle of the incoming data bits for proper sampling. Another important feature of the proposed quarter-rate concept is the inherent 1-to-4 demultiplexing of the input serial data stream. A new quarter-rate phase detector based on the non-linear early-late phase detector concept has been used to achieve the multi-Giga bit/s speed and to eliminate the need of the front-end data pre-processing (edge detecting) units usually associated with the conventional CDR circuits. An eight-stage differential ring oscillator running at 2.5 GHz frequency center was used for the voltage-controlled oscillator (VCO) to generate low-jitter multi-phase clock signals. The transistor level simulation results demonstrated excellent performances in term of locking speed and power consumption. In order to verify the accuracy of the proposed quarter-rate concept, a clockless asynchronous serial link incorporating the proposed concept and communicating two chips at 10 Gb/s has been modelled at gate level using the Verilog-A language and time-domain simulated.
Download or read book Design of Integrated Circuits for Optical Communications written by Behzad Razavi and published by John Wiley & Sons. This book was released on 2012-08-21 with total page 452 pages. Available in PDF, EPUB and Kindle. Book excerpt: The only book on integrated circuits for optical communications that fully covers High-Speed IOs, PLLs, CDRs, and transceiver design including optical communication The increasing demand for high-speed transport of data has revitalized optical communications, leading to extensive work on high-speed device and circuit design. With the proliferation of the Internet and the rise in the speed of microprocessors and memories, the transport of data continues to be the bottleneck, motivating work on faster communication channels. Design of Integrated Circuits for Optical Communications, Second Edition deals with the design of high-speed integrated circuits for optical communication transceivers. Building upon a detailed understanding of optical devices, the book describes the analysis and design of critical building blocks, such as transimpedance and limiting amplifiers, laser drivers, phase-locked loops, oscillators, clock and data recovery circuits, and multiplexers. The Second Edition of this bestselling textbook has been fully updated with: A tutorial treatment of broadband circuits for both students and engineers New and unique information dealing with clock and data recovery circuits and multiplexers A chapter dedicated to burst-mode optical communications A detailed study of new circuit developments for optical transceivers An examination of recent implementations in CMOS technology This text is ideal for senior graduate students and engineers involved in high-speed circuit design for optical communications, as well as the more general field of wireline communications.
Download or read book High Speed Devices and Circuits with THz Applications written by Jung Han Choi and published by CRC Press. This book was released on 2017-09-19 with total page 258 pages. Available in PDF, EPUB and Kindle. Book excerpt: Presenting the cutting-edge results of new device developments and circuit implementations, High-Speed Devices and Circuits with THz Applications covers the recent advancements of nano devices for terahertz (THz) applications and the latest high-speed data rate connectivity technologies from system design to integrated circuit (IC) design, providing relevant standard activities and technical specifications. Featuring the contributions of leading experts from industry and academia, this pivotal work: Discusses THz sensing and imaging devices based on nano devices and materials Describes silicon on insulator (SOI) multigate nanowire field-effect transistors (FETs) Explains the theory underpinning nanoscale nanowire metal-oxide-semiconductor field-effect transistors (MOSFETs), simulation methods, and their results Explores the physics of the silicon-germanium (SiGe) heterojunction bipolar transistor (HBT), as well as commercially available SiGe HBT devices and their applications Details aspects of THz IC design using standard silicon (Si) complementary metal-oxide-semiconductor (CMOS) devices, including experimental setups for measurements, detection methods, and more An essential text for the future of high-frequency engineering, High-Speed Devices and Circuits with THz Applications offers valuable insight into emerging technologies and product possibilities that are attractive in terms of mass production and compatibility with current manufacturing facilities.
Download or read book Integrated CMOS Circuits for Optical Communications written by Mark Ingels and published by Springer Science & Business Media. This book was released on 2004-01-12 with total page 200 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents several circuits that are required for the full integration of an optical transmitter in standard CMOS. The main emphasis is placed on high-speed receivers with a bitrate of up to 1 Gb/s. The possibility of including the photodiode in a receiver is investigated and the problems encountered are discussed. Concerning the transmitter aspect, a CMOS LED driver is described. The final chapter addresses electrical interference problems on a chip and proposes countermeasures. The various circuits in this book have all been realized and measurement results are presented, paving the way for single chip communication systems in which the optical interfaces are integrated on the same die as the digital circuitry.
