Download or read book 53 MHz Beam Loading Compensation for Slip Stacking in the Fermilab Main Injector written by J. Dey and published by . This book was released on 2005 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: Recently In-Phase and Quadrature (I & Q) was added to both the 53 MHz Feedback and Feedforward Beam Loading Compensation for Slip Stacking in the Fermilab Main Injector. With 53 MHz Feedback, we can now turn the 18 Radio Frequency (RF) Stations off down to below 100 V. In using I & Q on Feedforward, beam loading compensation to the beam on both the upper and lower frequencies of Slip Stacking can be applied as we slip the beam. I & Q theory will be discussed.
Download or read book Beam Loading Compensation for Slip Stacking written by and published by . This book was released on 2003 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: This paper discusses the beam loading compensation requirements to make slip stacking practical in the Fermilab main injector. It also discusses some of the current plans for meeting these requirements with a digital, direct RF feedback system.
Download or read book 53 MHZ Feedforward Beam Loading Compensation in the Fermilab Main Injector written by and published by . This book was released on 2003 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: 53 MHz feedforward beam loading compensation is crucial to all operations of the Main Injector. Recently a system using a fundamental frequency down converter mixer, a digital bucket delay module and a fundamental frequency up converter mixer were used to produce a one-turn-delay feedforward signal. This signal was then combined with the low level RF signal to the cavities to cancel the transient beam induced voltage. During operation they have shown consistently over 20 dB reduction in side-band voltage around the fundamental frequency during Proton coalescing and over 14 dB in multi-batch antiproton coalescing.
Download or read book Accelerator Physics at the Tevatron Collider written by Valery Lebedev and published by Springer. This book was released on 2014-05-29 with total page 496 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents the developments in accelerator physics and technology implemented at the Tevatron proton-antiproton collider, the world’s most powerful accelerator for almost twenty years prior to the completion of the Large Hadron Collider. The book covers the history of collider operation and upgrades, novel arrangements of beam optics and methods of orbit control, antiproton production and cooling, beam instabilities and feedback systems, halo collimation, and advanced beam instrumentation. The topics discussed show the complexity and breadth of the issues associated with modern hadron accelerators, while providing a systematic approach needed in the design and construction of next generation colliders. This book is a valuable resource for researchers in high energy physics and can serve as an introduction for students studying the beam physics of colliders.
Download or read book 2 5 MHz Feedforward Beam Loading Compensation in the Fermilab Main Injector written by and published by . This book was released on 2003 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: There are five 2.5 MHz ferrite cavities (h = 28) in the Main Injector with an R/Q of 500 that are presently used for coalescing for the Tevatron. For use with the Fermilab Recycler, feedforward (FF) beam loading compensation (BLC) is required on these cavities because they will be required to operate at a net of 2 kV. Under current Recycler beam conditions, the beam-induced voltage is of this order. Recently a system using a digital bucket delay module operating at 53 MHz (h = 588) was used to produce a one-turn-delay feedforward signal. This signal was then combined with the low level RF signal to the 2.5 MHz cavities to cancel the beam induced voltage. During current operation they have shown consistently to operate with over a 20 dB reduction in beam loading.
Download or read book R ponse aux impostures des lettres que les jansenistes publient contre les J suites written by and published by . This book was released on with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Challenges And Goals For Accelerators In The Xxi Century written by Stephen Myers and published by World Scientific. This book was released on 2016-02-26 with total page 856 pages. Available in PDF, EPUB and Kindle. Book excerpt: The past 100 years of accelerator-based research have led the field from first insights into the structure of atoms to the development and confirmation of the Standard Model of physics. Accelerators have been a key tool in developing our understanding of the elementary particles and the forces that govern their interactions. This book describes the past 100 years of accelerator development with a special focus on the technological advancements in the field, the connection of the various accelerator projects to key developments and discoveries in the Standard Model, how accelerator technologies open the door to other applications in medicine and industry, and finally presents an outlook of future accelerator projects for the coming decades.
Download or read book Relaes uyt Engelandt van t Gevecht voor Tabago Den 13 Maart 1677 written by and published by . This book was released on 1677 with total page 2 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Multi batch Slip Stacking in the Main Injector at Fermilab written by and published by . This book was released on 2007 with total page 4 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Main Injector (MI) at Fermilab is planning to use multi-batch slip stacking scheme in order to increase the proton intensity at the NuMI target by about a factor of 1.5.[1] [2] By using multi-batch slip stacking, a total of 11 Booster batches are merged into 6, 5 double ones and one single. We have successfully demonstrated the multibatch slip stacking in MI and accelerated a record intensity of 4.6E13 particle per cycle to 120 GeV. The technical issues and beam loss mechanisms for multibatch slip stacking scheme are discussed.
Download or read book Status of Slip Stacking at Fermilab Main Injector written by J. Reid and published by . This book was released on 2005 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: In order to achieve an increase in proton intensity, the Fermilab Main Injector (MI) will use a stacking process called ''slip stacking'' [1]. The intensity will be doubled by injecting one train of bunches at a slightly lower energy, another at a slightly higher energy, then bringing them together for the final capture. Beam studies have been performed for this process and we have already verified that, at least for low beam intensities, the stacking procedure works as expected [2]. For high intensity operation, development work of the feedback and feedforward systems was done during the last machine shut down, from August to November 2004 [3].
Download or read book Progress in Multi Batch Slip Stacking in the Fermilab Main Injector and Future Plans written by and published by . This book was released on 2008 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: The multi-batch slip stacking has been used for operations since January, 2008 and effectively increased proton intensity to the NuMI target by 50% in a Main Injector (MI) cycle. The MI accepts 11 batches at injection energy from the Booster, and sends two batches to antiproton production and nine to the NuMI beam line. The total beam power in a cycle was increased to 340 kW on average. We have been doing beam studies in order to increase the beam power to 400 kW and to control the beam loss. We will also discuss 12 batch slip stacking scheme which is going to be used for future neutrino experiments.
Download or read book Doubling Main Injector Beam Intensity Using RF Barrier written by and published by . This book was released on 2002 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Using rf barriers, 12 booster batches can be injected into the Fermilab Main Injector continuously, thus doubling the usual beam intensity. After that, adiabatic capture of the beam into 53 MHz buckets can be accomplished in about 10 ms. The beam loading voltages in the rf cavities are small and they can be eliminated by a combination of counterphasing and mechanical shorts.
Download or read book Theory and Design of Charged Particle Beams written by Martin Reiser and published by John Wiley & Sons. This book was released on 2008-09-26 with total page 634 pages. Available in PDF, EPUB and Kindle. Book excerpt: Although particle accelerators are the book's main thrust, it offers a broad synoptic description of beams which applies to a wide range of other devices such as low-energy focusing and transport systems and high-power microwave sources. Develops material from first principles, basic equations and theorems in a systematic way. Assumptions and approximations are clearly indicated. Discusses underlying physics and validity of theoretical relationships, design formulas and scaling laws. Features a significant amount of recent work including image effects and the Boltzmann line charge density profiles in bunched beams.
Download or read book High Luminosity Large Hadron Collider HL LHC written by G.. Apollinari and published by . This book was released on 2017 with total page 516 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book LHC Design Report written by and published by . This book was released on 2004 with total page 560 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Particle Physics Reference Library written by Stephen Myers and published by Springer Nature. This book was released on 2020-01-01 with total page 867 pages. Available in PDF, EPUB and Kindle. Book excerpt: This third open access volume of the handbook series deals with accelerator physics, design, technology and operations, as well as with beam optics, dynamics and diagnostics. A joint CERN-Springer initiative, the "Particle Physics Reference Library" provides revised and updated contributions based on previously published material in the well-known Landolt-Boernstein series on particle physics, accelerators and detectors (volumes 21A,B1,B2,C), which took stock of the field approximately one decade ago. Central to this new initiative is publication under full open access.
Download or read book Induction Accelerators written by Ken Takayama and published by Springer Science & Business Media. This book was released on 2010-10-05 with total page 345 pages. Available in PDF, EPUB and Kindle. Book excerpt: A broad class of accelerators rests on the induction principle whereby the accelerating electrical fields are generated by time-varying magnetic fluxes. Particularly suitable for the transport of bright and high-intensity beams of electrons, protons or heavy ions in any geometry (linear or circular) the research and development of induction accelerators is a thriving subfield of accelerator physics. This text is the first comprehensive account of both the fundamentals and the state of the art about the modern conceptual design and implementation of such devices. Accordingly, the first part of the book is devoted to the essential features of and key technologies used for induction accelerators at a level suitable for postgraduate students and newcomers to the field. Subsequent chapters deal with more specialized and advanced topics.
